ATTENTION: All Postings that advertise items for sale will be deleted from the Discussion Forum. You may post sale items for free in the Classifieds section. Sign up now.
Hey guys just did a clutch and trans swap in a 87 4wd s10 blazer. what a nightmare. i every thing back together clutch bleed ready to rock.then i noticed that my peddle was real hard at the bottom. so i pushed hard on it and herd a pop sound. keep in mind that also replaced my slave cylinder. now when the push rod puts pressure on clutch fork it make loud sqeekk noise. this noise even happens at a idle as soon as start the truck. help!
Did the flywheel look worn? If it's squeeking it's usually because the clutch is not engaging all the way up to the flywheel, bleed the system to make sure you get all the air out. This should fix the problem if everything else is good.
email josh
reply to message
post new message
search forums