 |
In Reply to "I lost a whole bunch of channels. Getting an error signal. I called the tech line and went through the diagnotics / reboot etc. and they could figure it out. Some of the transponders were not working. I have had the same receiver for 8 - 9 years. They said to get a new receiver. To me I think it should be all working or it is not, no inbetween?"
I had the same problem. Am only set up for sat91. I dont have the dual dish
Try doing a "check switch" It should come up with no switch detected. If you only get Sat 91, it should say under 91 odd and even. If one of them isnt there then do a check switch. (may have to run it a couple times) The Tech's dont even know that trick. Good luck |
email Ben
reply to message
search forums